Zfx Inhouse 5x - Control manual


Back 103: Current tool in the collet chuck is out of tolerance, remove tool by hand and insert
1) Open the Service tab

Home

2) Open the tab "Manual functions"

Service

3) Open the tool changer cover by pressing "Open".

4) Press "Cover" to unlock the machine hood. After pressing the button, it becomes blue. You have to wait to open the cover until the button becomes green.
The yellow colour of the button "Cover" indicates that the machine hood is open.

5) While holding the tool in the spindle with your hand, press the button "Open" for the spindle collet.
Attention: the tool must be held with the hand, otherwise it will fall down.

6) Put the tool back in the tool changer.

ManualFunctions

7) The machine hood can be closed now.
The T0 can be loaded now automatically in to the spindle.
Open the tool changer and select the T0 on Position 1.

Service

8) It is necessary that the machine hood is closed.

9) Click on "Load". So the machine will pick up the tool T0. After the measuring of the tool length, the message should disappear.
Otherwise it can be deleted by pressing "Reset".

MDI